Pc-concepts Full-Rated Router ADSL2+ Manual do Utilizador descarregar pdf (Página 55)

[Enabling Bridgeable Interfaces]

To enable bridging, you use the Bridge Configuration page to specify the interfaces that

can bridge data. Then, you use the System Mode page to enable the appropriate operating

mode.

1. If the Bridge Configuration page is not already displaying, click the Bridging tab.

The Bridge Configuration Page displays by default.

The page displays Enable/Disable links for Bridging, WAN-to-WAN Bridging, and Zero

Installation PPP bridge (ZIPB). The page also provides a table for specifying the interfaces on

which bridging will be performed. The table may be empty if bridging has not yet been

configured.

2. Select the interface names on which you want to perform bridging and click Add.

[Enabling Bridging Services]

After configuring the bridgeable interfaces, click one of the following links on the Bridge

Configuration Page:

• Bridging: Enable/Disable

• WAN to WAN Bridging: Enable/Disable

• ZIPB: Enable Disable

Each of the links displays the System Mode Page, where you can enable the appropriate

bridging operating mode.

5.5.2 LAN Configuration

This topic allows user to configure the interfaces on the ADSL/Ethernet router that

communicate with your LAN and USB computers.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 103 104

Sem comentários

Pc-concepts Full-Rated Router ADSL2+ Manual do Utilizador Página 55